Getting Started
R&S
®
CMW500
22User Manual 1173.9463.02 ─ 06
COM connector
COM connectors are bidirectional connectors. The two LEDs above a connector indicate
the connector state:
● The upper LED is lit as long as the R&S CMW500 is ready to receive signals.
●
The lower LED is lit as long as it transmits an RF signal.
OUT connector
OUT connectors are unidirectional output connectors. Compared to COM connectors,
OUT connectors can provide higher output powers. The LED is lit as long as the
R&S CMW500 transmits an RF signal.
Risk of instrument damage
The maximum input levels at all bidirectional RF connectors according to the front panel
labeling or the data sheet must not be exceeded.
In addition, the maximum input voltages of other input connectors at the front and rear
panel must not be exceeded.
RF connectors may warm up very much when high RF power is fed in!
2.2.1.11 Other Front Panel Connectors
Various control interface connectors and the AF connectors are located at the bottom of
the front panel.
USB Connectors
Single Universal Serial Bus connectors of type A (master USB), used to connect e.g. a
keyboard, mouse or other pointing devices, a printer or an external storage device (USB
stick, CD-ROM drive etc.). All front panel USB connectors comply with standard USB 2.0;
refer to the data sheet.
Risk of instrument damage
Never connect a device providing two USB connectors (e.g. Y-shaped cable) to the single
USB connector at the right side of the front panel. Connect such a device to two USB
connectors located on top of each other (front panel or rear panel).
Instrument Tour
To Next Page
Loading...
