Getting Started
R&S
®
CMW500
28User Manual 1173.9463.02 ─ 06
As a result the "General Purpose RF - Generator" dialog is opened.
Fig. 2-2: General Purpose RF Generator dialog
2. Click "Routing > Connector" and select your RF output connector. In the following we
assume that RF 1 COM is used.
3. Select the "Frequency" (1200 MHz) and "Level (RMS)" (–30 dBm) of the RF output
signal.
4. If your test setup contains a known, frequency-independent attenuation, enter the
value as an "External Attenuation (Output)".
5. Ensure that the "List Mode" is disabled (Off).
6. Select "Baseband Mode: Dual Tone".
7. In the "Baseband Configuration > Dual Tone" section, configure the properties of the
dual-tone signal. To superimpose two CW signals at different frequencies and levels,
set the "Offset Frequency" of both signals and define a "Ratio (Source 1 - Source 2)
that is different from 0 dB; see figures above and below.
8. Press ON | OFF to switch the RF generator on.
Trying Out the Instrument
To Next Page
Loading...
