Getting Started
R&S
®
CMW500
34User Manual 1173.9463.02 ─ 06
2. Select the applications for which an entry shall be displayed in the task bar.
3. To close the dialog press MEASURE or ESC.
Alternatively select an application at the bottom of the GUI. As a result the dialog
closes and the main view of the selected application is opened.
Accessing an application via the task bar
1. Press the TASKS key to display the task bar across the bottom of the GUI.
It contains a hotkey for each assigned measurement, generator, and signaling appli-
cation.
The color of the icon in a hotkey corresponds to the state of the application (OFF /
RUN / RDY for measurements or OFF / ON for generators and signaling generators).
2. Press one of the hotkeys to access the associated application.
Accessing dialogs within an application
Depending on the application, dialogs are accessed via softkey-hotkey combinations, via
the "Config" hotkey or via buttons within the GUI.
The following statements hold for most applications: Generator applications present most
settings directly in the main view. Measurement and signaling applications provide a sin-
gle configuration dialog containing most settings. In the main view measurement appli-
cations present measurement results and signaling applications present the most impor-
tant settings.
► Press the "Config" hotkey in the bottom right corner of the GUI to open the configu-
ration dialog of a measurement or signaling application.
Using softkeys and hotkeys
The softkeys are located on the right of the GUI, the hotkeys at the bottom of the GUI.
The present softkeys and hotkeys are adapted dynamically, depending on the application
and the context, e.g. configured parameters or signaling states. Hotkeys also change
depending on the active softkey.
Operating the Instrument
To Next Page
Loading...
