Getting Started
R&S
®
CMW500
47User Manual 1173.9463.02 ─ 06
By default, the R&S CMW500 is configured to use DHCP. This means that it is safe
to establish a physical connection to the LAN without any previous R&S CMW500
configuration.
●
If the network does not support DHCP, or a specific TCP/IP configuration is reques-
ted, the addresses must be set manually.
See "Manual TCP/IP Configuration" on page 47
Valid IP addresses
If your network does not support DHCP, or if you choose to disable dynamic TCP/IP
configuration, you must assign valid address information before connecting the
R&S CMW500 to the LAN. Contact your network administrator to obtain a valid IP
address, because connection errors can affect the entire network.
On instruments equipped with a signaling unit and an "Ethernet Switch H661A" (option
R&S CMW-B661A), some applications require a special IP configuration of the "Lan
Remote" network adapter. In these scenarios the network adapter belongs to the internal
IPv4 subnet of the instrument and can not be used for remote control.
For configuration of a compatible "Lan Remote" IP address, see chapter 4.4.9, "IP Subnet
Configuration", on page 101.
Manual TCP/IP Configuration
To disable dynamic TCP/IP configuration and enter the TCP/IP address information
manually proceed as follows:
1.
Obtain the IP address and subnet mask for the R&S CMW500 and the IP address
for the local default gateway from your network administrator. If needed, also obtain
the name of your DNS domain and the IP addresses of the DNS and WINS servers
on your network.
2. Perform the startup procedure.
3. Press the SETUP key to open the "Setup" dialog.
4. In the "Lan Services" section, disable DHCP and enter your address information, e.g.:
Administrative Tasks
To Next Page
Loading...
