Rohde & Schwarz CMW500 - Page 94

System Overview
R&S
®
CMW500
78User Manual 1173.9463.02 ─ 06
Table 3-4: Assignments for two sub-instruments
Sub-instrument 1 Sub-instrument 2
Generator Controller entry "GPRF Generator" "GPRF Generator"
Measurement Controller entry "GPRF Power" "GPRF Power"
Remote commands
...:GPRF:GEN:...
...:GPRF:MEAS:POW:...
...:GPRF:GEN:...
...:GPRF:MEAS:POW:...
Remote Settings
Assigned Instrument = 1 Assigned Instrument = 2
Each signal path and RF connector is fix assigned to one specific sub-instrument. The
RX and TX modules of both sub-instruments are named identically but refer to different
physical modules.
For an instrument with two RX and TX signal paths and two frontends, each sub-instru-
ment contains one RX module, one TX module and three RF connectors. If two RX and
TX signal paths and only one advanced frontend are available, one sub-instrument con-
tains two RF connectors and the other sub-instrument one RF connector. For more details
refer to the following table.
Table 3-5: Signal path resources for two sub-instruments, two RX and TX signal paths
Sub-instrument 1 Sub-instrument 2
RX/TX module names RX 1, TX 1 (physically: RX 1, TX 1) RX 1, TX 1 (physically: RX 2, TX 2)
RF connectors (2 fron-
tends)
RF 1 COM, RF 1 OUT, RF 2 COM RF 3 COM, RF 3 OUT, RF 4 COM
RF connectors (1 fron-
tend)
RF 1 COM, RF 1 OUT RF 2 COM
Sub-Instruments