Rohde & Schwarz PR100 - Page 159

R&S PR100 User Manual
*Parameters:
0 Manual
1 Automatic
Example:
OUTPut:AUX:AUTO? -> 1
d
OUTPut
. :BITaux[<numeric_suffix>]
. . [:STATe] <Boolean>
Sets the antenna-selection bits. In case another antenna is chosen via
ROUT:SEL, these settings are changed again.
<numeric_suffix>
1 bit 1 corresponds to antenna-bit 1
2 bit 2 corresponds to antenna-bit 2
*Parameters:
ON Bit set to 1
OFF Bit set to 0
Example:
OUTPut:BITaux2 ON
d
OUTPut
. :BITaux[<numeric_suffix>]
. . [:STATe] ?
Query of the antenna-selection bits.
Result:
0 OFF
1 ON
Parameters:
none
Example:
OUTPut:BITaux2? -> 1