TRACe|DATA
. :UDP
. . :FLAG
. . . :OFF <ip-address> , <ip-port>, <flag> {, <flag>...}
Sets a UDP-address and removes the specified flags if present. If the
maximum number of UDP addresses (TRACe:UDP? MAX) has been reached
an error is generated: -310, “Maximum number of UDP addresses exceeded”.
Parameters:
<ip-address> string representing IP dot notation of IP address (e.g.
172.17.75.18)
<numeric_value> integer port number in the range [0,65535] (16 bit)
<flag> See Table 20 for flags in Section 12.1.
Remark:
If the UDP-address is not in the list, it is added to it. Otherwise, it is modified.
*RST state:
The “*RST” command has no effect on these settings.
After a power down, the UDP-address list only contains the default entry
(index 0). The default is retained.
Example:
TRACe:UDP:FLAG:OFF “123.456.789.012”, 5555, “VOLT:AC”, “SWAP”
To Next Page
Loading...
