EasyManua.ls Logo

Roland DiscLab CDX-1

Roland DiscLab CDX-1
252 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
196
Insert effect algorithm list
11. COSM BASS AMP (COSM Bass Guitar Amp)
This is a multi-effect designed for bass guitar. This features an amp sound that uses a preamp and speaker modeling.
Parameter (full name) Setting Function
COMP (Compressor): Compressor the entire output signals when the input volume exceeds a specified value.
Effect On/Off (Effect On/Off) OFF, ON This parameter turns the compressor effects on/off.
Sustain (Sustain) 0–100 Adjusts the range (time) over which low-level signals are boosted. Larger
values will result in longer sustain.
Attack (Attack) 0–100 Adjusts the strength of the attack. Larger values will result in a sharper
attack, creating a more clearly defined sound.
Level (Output Level) 0–100 Adjusts the volume.
P.AMP (Preamp): Adjust the distortion and tone of the guitar sound.
Effect On/Off (Effect On/Off) OFF, ON Turns the preamp effect on/off.
Amp Type (Amp Type) *1 AC It produces the vintage sound of an early transistor amp.
AMG It produces the sound of a large double-stack vacuum tube amp with ultra-
lows and a crisp edge.
Volume (Volume) 0–100 Adjusts the volume and distortion of the amp.
Bass (Bass) -100–+100 Adjusts the tone for the low frequency range.
Middle (Middle) -100–+100 Adjusts the tone for the middle frequency range.
Treble (Treble) -100–+100 Adjusts the tone for the high frequency range.
Master (Master) 0–100 Adjusts the volume of the entire preamp.
Bright (Bright) *2 OFF, ON Turns the bright setting on/off. Bright is switched on to create a lighter and
crisper tone.
Gain (Gain) *3 LOW, MIDDLE, HIGH Adjusts the distortion of the amp. Distortion will successively increase for
settings of “LOW,” “MIDDLE” and “HIGH.”
*1 When all Bass, Middle and Treble are set to “0,” no sound may be produced depending on the “Amp Type” setting.
*2 Depending on the “Amp Type” setting, this may not be displayed.
*3 successively increase for settings of “LOW,” “MIDDLE” and set to “MIDDLE.” So, normally set it to “MIDDLE.”
Compressor Equalizer
(*1)
Wah
Noise
Suppressor
Chorus
(*2)
Flanger
Pitch Shifter
Phaser
Doubling
Tr emolo/Pan
Delay
*1 Equalizer can be replaced with Wah.
PreAmp
Speaker
Simulator
*2 Chorus can be replaced one of the following effects.

Table of Contents

Other manuals for Roland DiscLab CDX-1

Related product manuals