34
Basic operation of the CDX-1
Turning Off the Power
1. Turn off the power of the connected equipment in the opposite order from which
they were turned on (p. 33).
2. Press the Power Switch.
fig.15-05
The message “Shutdown?” appears in the
display.
3. If you are ready to turn off the power, press [YES/ENTER].
The power will turn off.
Press [NO/EXIT], shutdown will be canceled.
● If the display asks “You’ll lose PAD/SEQ data during shutdown. Sure?”
If any pad/sequence is held in internal memory of CDX-1 when you carry out
shutdown, the massage “You’ll lose PAD/SEQ data during shutdown. Sure?”
appears.
1. If you are ready to turn off the power, press [YES/ENTER].
The power will turn off.
* If a CD-RW disc is inserted in CDX-1, a message “Save SONG before shutdown?” appears. In
this case, see following process of “If the display asks Save SONG before shutdown?”
Press [NO/EXIT], shutdown will be canceled.
● If the display asks “Save SONG before shutdown?”
When the CD-RW disc is inserted in CDX-1, the massage “Save SONG before
shutdown?” appears in the display.
1. If you wish to save the song data, press [YES/ENTER].
A message “Processing...” appears and CDX-1 saves setting of SONG (Parameter of
Mixer, effects etc.) in CD-RW disc. When saving is completed, the power will turn
off.
If you press [NO/EXIT], power will be turned off without saving of data. All the
settings (Mixer, effects etc.) after inserting CD-RW disc will be lost.
●
To turn off the power of the CDX-1, you must use the POWER switch rather than
unplugging the AC adaptor from the outlet or disconnecting the AC ADAPTOR jack.
❍ If you turn off the power without using the POWER switch while the internal
CD-RW drive is operating, the CD-RW drive may malfunction.
❍ If the power supply is interrupted due to an unexpected power failure or other
cause, avoid moving the CDX-1, and turn the power on once again when the
power resumes.
❍ CDX-1 saves some parameters like system setting when power turned off. For this
reason if you simply unplug the AC adaptor without using the POWER switch, the
mixer settings, effect patch data, and unsaved sample data will all be lost. Please
use caution.
Once you carry out turning off
the power, pad/sequence held
in internal memory of CDX-1
will be lost. If you wish to keep
the pad/sequence, you must
save it on a CD-RW disc before
shutdown.
➔ “Saving Pad/
Sequence” (p. 67).
For details of saved Song
settings, refer to “Saving Song
settings on a CD-RW disc”
(p. 126).
This message appears even in
case you have not changed
setting of Song.
To Next Page
Loading...
Need help?
General
