36
Basic operation of the CDX-1
Removing a disc
1. Press the EJECT button.
The disc tray will open.
* If a CD-RW disc is inserted in CDX-1, a message “Save SONG before eject?” appears. In this case,
see following process of “If the display asks Save SONG before eject?”
2. Remove the disc from the disc tray.
3. Press the EJECT button once more.
The disc tray will close.
The disc tray will also close if you press lightly on the front of the tray.
●
If the display asks Save SONG before eject?
When the CD-RW disc is inserted in CDX-1, the massage “Save SONG before eject?”
appears in the display.
1. If you wish to save the song data, press [YES/ENTER].
A message “Processing...” appears and CDX-1 saves setting of SONG (Parameter of
Mixer, effects etc.) in CD-RW disc. When saving is completed, the disc tray will open.
If you press [NO/EXIT], a message “Eject disc? (not saved)” appears.
Press [YES/ENTER]:
The disc tray will open without saving of data. All the settings (Mixer, effects etc.)
after inserting CD-RW disc will be lost.
Press [NO/EXIT]:
Removing disc will be canceled.
For details of saved Song
settings, refer to “Saving Song
settings on a CD-RW disc”
(p. 126).
If the disc tray does not open
If the power is turned off with the disc still in the drive (such as due to a power
failure), the disc tray cannot be opened by pressing the eject button. In this case, you
can insert a piece of wire to force the tray open.
1. Turn off the power of the CDX-1.
2. Insert a thin object such as a wire into the emergency eject hole.
The disc tray will open.
fig.15-09
To Next Page
Loading...
Need help?
General
