71
Playing the pad samples
Playing the pad samples
Crossfading the pad samples you play
—Pad Crossfade
By using Pad Crossfade, you can play pad samples without creating gaps between
the sounds of each pad. Each time you press a pad, its sample will be automatically
crossfaded (faded in and faded out).
Pad samples can be recorded directly to a CD-R disc only when Pad Crossfade is
turned on. (➔ “Recording samples played using Pad Crossfade on a CD-R disc “;
p. 162)
1. Press [PAD X FADE].
[PAD X FADE] will light, and Pad Crossfade will be turned on.
2. Press a pad to play its sample.
3. When you press another pad while the first sample is playing, the first-played
sample will be faded-out, and the sample of the subsequently played pad will be
faded-in as it starts playing.
4. To cancel Pad Crossfade, press [Pad X FADE].
[PAD X FADE] will go out, and Pad Crossfade will be turned off.
All pads will sound in Trigger
mode, regardless of their
actual mode setting.
● Trigger mode:
The sound will begin playing
when you press the pad, and
will continue playing even
when you release the pad. The
sound will stop when you
press the pad once again.
To Next Page
Loading...
Need help?
General
