4-2 Installing a Tool
60
Chapter 4 Getting Ready for and Performing Cutting Chapter 4 Getting Ready for and Performing CuttingChapter 4 Getting Ready for and Performing Cutting
Loosely tighten the collet with
tool.
While supporting the tool to keep it
from falling, twist and lightly secure
the collet.
Fully tighten the collet.
While holding the tool with the ngers
to keep it from falling, tightly secure the
collet by using two spanners.
After installing the tool, set the reference
position (Z and XY origin).
P. 61, "Setting Origin Point"
Spanner (Large)
Spanner (Small)
To Next Page
Loading...
