Roland MDX-40A - Page 7

Contents
5
Operations are Ignored. ...............................................................................................................78
The Spindle Doesn't Rotate. .......................................................................................................79
Abnormal Cutting is Performed. ...............................................................................................79
The Origin is Misaligned...............................................................................................................79
The Feed Rate or Spindle Speed is Wrong. ............................................................................79
The Cutting Results are Not Attractive. ..................................................................................79
What to Do If a Flashing Error Is Displayed ...........................................................................80
Installation is Impossible .............................................................................................................80
Uninstalling the Driver .................................................................................................................81
5-5 Responding to an Error Message ........................................................83
For Connection of Equipment ...................................................................................................83
Detection Failure ............................................................................................................................83
Pause ...................................................................................................................................................83
Emergency Stop ..............................................................................................................................84
5-6 Power Rating and Serial Number Locations ........................................86
5-7 NC Code Specications .......................................................................87
Settings for NC Codes ...................................................................................................................87
Items Related to the Mechanical Specications .................................................................87
Interpretation of Omitted NC Codes .......................................................................................88
Word List ............................................................................................................................................89
5-8 Specications .......................................................................................91
Expansion Connector ....................................................................................................................91
External View ....................................................................................................................................92
Dimensional Drawings of the Table Area ...............................................................................93
Main Specications ........................................................................................................................94
System Requirements for USB Connection ...........................................................................95
http://www.rolanddg.com/
Copyright © 2009 Roland DG Corporation
Company names and product names are trademarks or registered trademarks of their respective holders.