74
• The sound is too soft
Is GT TIME (Gate Time) set too low?
If you are playing a sound with a soft attack, set a longer Gate Time.
Is TRIG SENS in the SYSTEM parameter group too low?
Set Velocity Seneitivity to an appropriate value.
• The volume does not change in response to playing dynamics
Is CURVE in the SOUND parameter group set to “Const”?
Set Velocity Curve to an appropriate value.
• The note duration of the MIDI sound module does not change even though you
adjusted GT TIME
Does the MIDI sound module recognize Note O messages? Or has it been set to a mode in which
it does not recognize Note O messages?
Refer to the operation manual of the MIDI sound module.
• When you select a Patch, the sound of the MIDI sound module also changes
Has PGM CH (Program Change) in the MIDI parameter group been set for a pad?
Set Program Change to “OFF” .
• The MIDI sound module does not change sounds in response to Program
Change messages
Is PGM CH in the MIDI parameter group set to “OFF”?
Make Program Change settings.
Are the MIDI Channel of the pad and the MIDI channel of the MIDI sound module set
appropriately?
Check the MIDI Channel of the pad and the MIDI channel of the MIDI sound module.
Is the MIDI sound module able to respond to Program Change messages? Or is it set to a mode in
which it does not recognize Program Change messages?
Refer to the operation manual of the MIDI sound module.
• Two sounds are played
Is the Layer function set to On?
Turn the Layer function o.
• When the pad is struck, the sound is intermittent
Is the Gate Time set to ALT?
Set the Gate Time to something other than ALT.
When playing the internal sound generator of the SPD-20X
• No sound
Does the Basic Channel of the SPD-20X match the MIDI Channel of the external MIDI device?
Set both devices to the same channel.
The receive channel for program change and control change is channel 10.
MEMO
To Next Page
Loading...
Need help?
General
