Configuring the AP
Configuring Device Settings
Ruckus Wireless Indoor AP 100.2.0 User Guide, 800-70892-001 Rev A 116
• New Password: When you are changing the password, type the new
password that you want to use. The default password is sp-admin. The
password must consist of six to 32 alphanumeric characters only.
• Confirm New Password: Retype the new password to confirm.
7 Under Login remote authentication, click the TACACS+ State box to enable
TACACS+ authentication, if required. Terminal Access Controller Access-Control
System Plus (TACACS+) is an AAA protocol used to authenticate administrator
login to this device. Users can be authenticated/authorized to monitor, operate
or configure this device. Default is disabled. Administrators can be assigned any
of the following three administration privilege levels:
• Super Admin (Perform all configuration and management tasks)
• Operator Admin (Change settings affecting single AP's only)
• Monitoring Admin (Monitoring and viewing operation status only)
8 If TACACS+ server state is enabled, then configure the TACACS+ server settings:
• TACACS+ server: IPv4 or IPv6 server address.
• TACACS+ port: 49 is the default, but it can be set to any available TCP port.
• TACACS+ Service: Login name.
• Share Key: TACACS+ Password.
• Confirm Share Key: TACACS+ Password.
9 Click Update Settings to save and apply your changes.
To Next Page
Loading...
