Configuring the AP
Configuring Wireless Settings
Ruckus Wireless Indoor AP 100.2.0 User Guide, 800-70892-001 Rev A 133
Broadcast SSID This option controls whether or not the WLAN SSID is visible to
anyone looking for wireless networks. Disabling (hiding) the
SSID requires the user to be told the correct SSID before they
can connect to your network.
SSID This is the publicly-broadcast “name” of your wireless network.
SSIDs can contain up to 32 alphanumeric characters and are
case-sensitive. The maximum SSID length can only contain
between 2 and 32 characters, including characters from ! (char
33) to ~ (char 126).
Threshold Settings This button opens a page where you can configure the
Protection Mode you activated on the Configuration > Wireless
> Advanced > Wireless [#] page. If Protection Mode is not active,
ignore this option.
For more information,
refer to “Setting Threshold Options” on
page 141
.
Rate Limiting This button opens a page where you can configure upload and
download limits per station. For more information, refer to
“Rate
Limiting” on page 143
.
Access Control This button opens a page where you can configure access
controls for the WLAN. For more information, refer to
“Controlling Access to the Wireless Network” on page 144.
Packet Forward
Isolated: Selecting Isolated causes the traffic from this WLAN
to terminate at the AP.
Bridge to WAN: The default setting, Bridge to WAN forwards
packets arriving on this WLAN to the WAN (uplink) port and
eventually to their external destinations using Layer 2
forwarding.
Local Subnet NAT and Route to WAN: This setting allows
routing of wireless packets to their destinations using Layer 3
network address translation (NAT).
Bridge to L2TP Tunnel: Uses Layer 2 Tunneling Protocol to
deliver packets encapsulated with an L2TP header in UDP
datagrams.
Table 46. WLAN options (Continued)
To Next Page
Loading...
