Installing the AP
Step 1: Preconfiguring the AP
Ruckus Wireless Indoor AP 100.2.0 User Guide, 800-70892-001 Rev A 83
2. Preparing the Administrative Computer
NOTE The following procedure is applicable if the administrative computer is
running Windows XP or Windows 7. If you are using a different operating system,
refer to the documentation that was shipped with your operating system for
information on how to modify the computer’s IP address settings.
1 On your Windows XP or Windows 7 computer, open the Network Connections
(or Network and Dial-up Connections) control panel according to how the Start
menu is set up:
• On Windows XP, click Start > Control Panel > Network Connections.
• On Windows 7, click Start > Control Panel > Network and Internet >
Network and Sharing Center > Change Adapter Settings.
2 When the Network Connections window appears, right-click the icon for Local
Area Connection, and then click Properties.
NOTE Make sure that you configure the Local Area Connection Properties, not the
Wireless Network Connection Properties.
3 When the Local Area Connection Properties dialog box appears, select Internet
Protocol (TCP/IP) (TCP/IPv4 in Windows 7) from the scrolling list, and then
click Properties. The Internet Protocol (TCP/IP) Properties dialog box appears.
4 Write down all of the currently active network settings. You will need this
information later when you restore your computer to its current network
configuration.
5 Click Use the following IP address, and then configure the IP address settings
with the values listed in Ta ble 4 0 . For a sample configuration, refer to Figure 37.
6 Click OK to save your changes and close the TCP/IP Properties dialog box.
7 Click OK again to close the Local Area Connection Properties dialog box.
Table 40. Configure your computer’s IP address settings
IP address 192.168.0.22 (or any address in the 192.168.0.x network—with
the exception of
192.168.0.1, which is the default IP address
assigned to the AP)
Subnet mask
255.255.255.0
NOTE:
You can leave the Default Gateway and DNS server fields blank.
To Next Page
Loading...
