Web-based Configuration Guide System Settings
190
2. Configuring Trap v3
Application Scenarios
During device monitoring, if the device is suddenly disconnected or encounters an
abnormality, and the third-party monitoring software cannot detect and handle the
abnormal situation in a timely manner, you can configure the device with a destination IP
address of 192.168.110.87 and a port number of 167 to enable the device to send a v3
trap, which is a safer trap compared with v1/v2c traps.
Configuration Specification
According to the user’s application scenario, the requirements are shown in the following
table:
Table 5-11 User Requirement Specification
IP address and port
number
The destination host IP is 192.168.110.87, and the port
number is 167.
Select the v3 version and trapv3_ ruijie for the user name.
Authentication
protocol/authentication
password
Encryption
protocol/encryption
password
Authentication protocol/password: MD5/Ruijie123
Encryption protocol/password: AES/Ruijie123
Configuration Steps
(1) Select the v3 version in the Trap Setting interface and click Save.
To Next Page
Loading...
