Ruijie Reyee RG-RAP Series

Web-based Configuration Guide System Settings
177
5.6.4 SNMP Service Typical Configuration Examples
1. Configuring SNMP v2c
 Application Scenario
You only need to monitor the device information, but do not need to set and deliver it. A
third-party software can be used to monitor the data of nodes like 1.3.6.1.2.1.1 if v2c
version is configured.
 Configuration Specification
According to the user’s application scenario, the requirements are shown in the following
table:
Table 5-6 User Requirement Specification
Item
Description
View range
Included rule: the OID is .1.3.6.1.2.1.1, and the custom view
name is “system”.
Version
For SNMP v2c, the custom community name is
“Ruijie_com”, and the default port number is 161.
Read & write permission
Read-only permission.
 Configuration Steps
(1) In the global configuration interface, select v2c and set other settings as default. Then,
click Save.