Web-based Configuration Guide System Settings
176
character categories, including uppercase and lowercase
letters, digits, and special characters.
Note: This parameter is mandatory when the security level
is authentication and encryption, or authentication but no
encryption.
Encryption Protocol,
Encrypted Password
Encryption protocols supported: DES/AES/AES192/AES256.
Encryption password: 8-31 characters. Chinese characters,
full-width characters, question marks, and spaces are not
allowed.
It must contain at least three character categories,
including uppercase and lowercase letters, digits, and
special characters.
Note: This parameter is mandatory when the security level
is authentication and encryption.
Caution
The security level of v3 users must be greater than or equal to that of the group.
There are three security levels, among which authentication and encryption requires
the configuration of authentication protocol, authentication password, encryption
protocol, and encryption password. Authentication but no encryption only requires
the configuration of authentication protocol and encryption protocol, while no
authentication and encryption does not require any configuration.
5. Viewing v3 Device Identifier
In Network mode, choose System > SNMP > View/Group/Community/Client
Access Control > SNMP v3 Device Identifier List
View the v3 device identifier in the SNMP v3 Device Identifier List pane.
To Next Page
Loading...
Need help?
General
