Web-based Configuration Guide Network Settings
140
○ Not Join: Configure the port not to allow packets from this VLAN to pass through.
For example, if VLAN 10 and VLAN 20 are not added to port 2, port 2 will neither
receive nor send packets from or to VLAN 10 and VLAN 20.
4.8 Changing MAC Address
For RG-RAP2260(G), RG-RAP2260(E), RG-RAP6260(G), RG-RAP6262(G), RG-RAP2260(H), RG-
RAP6260(H), RG-RAP6260(H)-D, RG-RAP2266, RG-RAP2260, RG-RAP1261, RG-RAP1260 and
RG-RAP6262 models: In Local Device mode, choose Network > WAN > WAN
For other RAP models: Choose ( WLAN > APs > Manage >) Network > WAN >
WAN
ISPs may restrict the access of devices with unknown MAC addresses to the Internet for
the sake of security. In this case, you can change the MAC address of the WAN port.
Click to expand Advanced Settings, enter the MAC address, and click Save. You do not
need to change the default MAC address unless in special cases.
In the router mode, change the MAC address of the LAN port on Network > LAN.
Caution
Changing the MAC address will disconnect the device from the network. You need to
reconnect the device to the network or restart the device. Therefore, exercise caution
when performing this operation.
To Next Page
Loading...
