Ruijie Reyee RG-RAP Series

Web-based Configuration Guide System Settings
188
Parameter
Description
It must contain at least three character categories,
including uppercase and lowercase letters, digits, and
special characters.
Note: This parameter must be set when the Security Level
is Auth & Security.
Caution
The destination host IP address of trap v1/v2c/v3 users cannot be the same.
(3) Click OK.
5.6.6 Trap Service Typical Configuration Examples
1. Configuring Trap v2c
 Application Scenarios
During device monitoring, if the device is suddenly disconnected or encounters an
abnormality, and the third-party monitoring software cannot detect and handle the
abnormal situation in a timely manner, you can configure the device with a destination IP
address of 192.168.110.85 and a port number of 166 to enable the device to send a v2c
trap in case of an abnormality.
 Configuration Specification
According to the user’s application scenario, the requirements are shown in the following
table:
Table 5-10 User Requirement Specification
Item
Description
IP address and port
number
The destination host IP is 192.168.110.85, and the port
number is 166.
Version
Select the v2c version.
Community name/User
Trap_ruijie