Web-based Configuration Guide System Settings
187
Table 5-9 Trap v3 User Configuration Parameters
IP address of the trap peer device. An IPv4 or IPv6 address
is supported.
The port range of the trap peer device is 1 to 65535.
Name of the trap v3 user.
At least 8 characters.
It must contain at least three character categories,
including uppercase and lowercase letters, digits, and
special characters.
Admin, public or private community names are not
allowed.
Question marks, spaces, and Chinese characters are not
allowed.
There are three security levels for a trap user, which are
"Auth & Security", "Auth & Open", and "Allowlist &
Security".
Auth Protocol, Auth
Password
Authentication protocols supported:
MD5/SHA/SHA224/SHA256/SHA384/SHA512.
Authentication password: 8-31 characters. Chinese
characters, full-width characters, question marks, and
spaces are not allowed. It must contain at least three
character categories, including uppercase and lowercase
letters, digits, and special characters.
Note: This parameter must be set when the Security Level
is Auth & Security or Auth & Open.
Encryption Protocol,
Encrypted Password
Encryption protocols supported: DES/AES/AES192/AES256.
Encryption password: 8-31 characters. Chinese characters,
full-width characters, question marks, and spaces are not
allowed.
To Next Page
Loading...
