Web-based Configuration Guide Network Settings
128
device is configured or global configuration does not need to be synchronized to the
device, you can disable the self-organizing network discovery function.
4.1.3 Configuration Steps
Note
If you need to switch the work mode to wireless bridging mode, please see Wireless
Repeater Mode for details.
For RG-RAP2260(G), RG-RAP2260(E), RG-RAP6260(G), RG-RAP6262(G), RG-RAP2260(H), RG-
RAP6260(H), RG-RAP6260(H)-D, RG-RAP2266, RG-RAP2260, RG-RAP1261, RG-RAP1260 and
RG-RAP6262 models: In Local Device mode, choose Overview > Device Details
For other RAP models: Choose ( WLAN > APs > Manage) Overview > Device
Details
Click the current work mode to change the work mode.
AC function switch: If a device works in the router mode and the self-organizing
network discovery function is enabled, you can enable or disable the AC function. After
the AC function is enabled, the device in the router mode supports the virtual AC
function and can manage downlink devices. If this function is disabled, the device needs
to be elected as an AC in self-organizing network mode and then manage downlink
devices.
To Next Page
Loading...
Need help?
General
