Sanyo SUPER BL P5 - Page 116

7. EXPLANATION OF PARAMETERS
7－21
●
Offline automatic tuning procedure
Fig. 7-12 Offline automatic Tuning Operation
After offline automatic tuning is completed, press the key to return to the set screen from the ready
screen, then return to the initial screen using the key.
When the initial screen is displayed, the "OVF (excessive deviation)" alarm occurs.
When the offline automatic tuning is disabled by a main circuit power off status or an alarm, the following
is displayed:
＊Test 1
Tune Not Ready
The offline automatic tuning is enabled, the Tune Gain set screen appears.
Set page 1 using the or
key.
Select tuning rigidity (High, Middle or Low) using the or key.
* Test 1
Tune Gain #####
* Test 1
Tn_G Rdy Y=3,N=0
Flickers
3
Test screen
Tune gain set
During tuning
Completion Error
.... During servo tuning,
an error occurs.
* Test 1
Tn_G Completed
A
fter
completion,
the buzzer
sounds.
A
short
beep is
sounded.
* Test 1
Tn_G Error
* Test 1
Tn_G Running
Stop
Execute
: The servo ready signal is turned off and the servo is turned on.
WR
0
0
Tn_G ready
screen
: Servo ON
cancel
(Servo OFF)
: Cancel
(Servo OFF)
0