7. EXPLANATION OF PARAMETERS
7－2
7.1 Remote Operator (Optional)
This section explains the basic operation of the remote operator. By using the remote operator, parameter
change, monitoring of velocity and current, alarm trace and various tests are possible.
7.1.1 Outline of Remote Operator
The following figure shows the remote operator.
Fig. 7-1 Remote Operator
Table 7-1 Specifications of Remote Operator
Item Specification
Power supply Supplied from the Servo Amplifier
Connection method Connector connection using an exclusive cable
(cable length: 2 m)
Ambient temperature During operation status
0°C to +50°C (32°F to 122°F)
During storage
−20°C to +65°C (-4°F to 149°F)
Working atmosphere Free from oil mist, corrosive gas and dust
Hand Band
Liquid crystal panel
(16 characters × 2 lines)
Operation keys
Connector to
the amplifier Check pin
Brightness
adjusting control
Since the liquid crystal panel may be broken if the remote operator is dropped, handle it with
care.
To Next Page
Loading...
