5. INSTALLATION
5 - 4
5.2 Servomotor Installation
The Servomotor is designed to be installed indoors.
Note the following precautions on the position and method for installation.
5.2.1 Installation Place
Install the Servomotor at an indoor site by referring to the following.
• Ambient temperature : 0 to 40°C
• Storage temperature : − 20 to 65°C
• Ambient humidity : 20 to 90%
• Well-ventilated places without corrosive or explosive gas
• Places free from dust or foreign materials
• Places easy to check and clean
• Always keep the oil seal lip away from oil or the Servomotor away from a large amount of water, oil or
cut liquid. The Servomotor can be protected from slight splashes by means taken on it.
5.2.2 Installation Procedure
● Direction of installation
• The Servomotor can be installed horizontally or on/under the end of a shaft.
• Set the cable from the motor with its end downward.
• At vertical installation, provide a cable trap to prevent oily water from going to the motor.
Fig. 5-4
Lead wire
Cable trap
To Next Page
Loading...
