5. INSTALLATION
5 - 3
5.1.2 Installation Procedure
● Direction and Position of Installation
Install the Servo Amplifier vertically and fix the amplifier by tightening M5 screws onto the four mounting
holes as in the figure below.
Fig. 5-1
● Board arrangement conditions
• Provide a space of 50 mm at minimum on both upper and lower sides of the Servo Amplifier so as
not to prevent air from flowing out of the radiator or the amplifier. If heat remains on the upper part
of the amplifier, install a fan to force air to flow.
• Provide a space of 10 mm at minimum on both sides of the amplifier so as not to prevent radiation
from the heat sink on the side of the amplifier or air from flowing out of it.
Fig. 5-2
M5 M5
M5 M5
Servo Amp.
Rear installation
Front installation
Side view
Servo Amplifier
Draft
50 mm min.
50 mm min.
Front view
Servo Amplifier
50 mm min.
Fan
10 mm min.
50 mm min.
To Next Page
Loading...
