6. OPERATION
6－10
6.3.2 Jog Operation
7 Turn ON the 200 VAC of r-t (① wires).
→ The servo amplifier POWER and the right-hand
figure portion of 7-segment LED are lighted.
→ When the 7-segment LED displays "U", proceed to
section 6.4.
→ The remote operator screen display becomes the
[Push Mode Key] screen as shown on the right and
a "beep" sound is emitted.
Push
〔
MODE
〕
ke
8 Change the remote operator setting and reset the
OT (over travel) signal.
The procedure is as follows:
Repeat pushing , and or
keys
until the right screen appears.
Push the , key twice and the key
once so that the right screen will appear.
Push the key so that the right screen will
appear.
＊
Para. Set3 1
Func0
: 00000000
＊
Para. Set3 1
Func0
: 00100000
WR
Completed
1
Func0
:
00100000
9 Make the JOG operation function effective using
the remote operator.
Push the key a few times until the right
screen appears.
Push the and keys in that order so that
the right screen will appear.
＊
Para. Set3 7
Func6
: 00000000
＊
Para. Set3 7
Func6
: 01000000
１
2
1
To Next Page
Loading...
