6. OPERATION
6－11
Push the key so that the right screen will
appear.
(Func6 bit6 “1” described above returns to “0” by
turning the power on again.)
WR
Completed
7
Func6
:
01000000
10 Turn on the 200 VAC (② wires) of R-S-T.
The 7-segment LED is light as shown in the right
figure.
11 Start the JOG operation.
Push the and keys so that the
right screen will appear.
Push the , and keys so that the
right screen will appear.
The 7-segment LED draws a figure of 8.
Continue pushing the key until the right
screen appears.
The remote operator keeps sounding "beep, beep"
and the motor rotates counterclockwise (CCW) in
10 min
−
1
when viewed from its shaft side.
Then continue pushing the key until the right
screen appears.
In this mode, the motor rotates clockwise (CW) in
10 min
−
1
.
＊
Test
0
JOG
Set min
-1
WR
＊
Test
0
JOG Set 10min
-1
＊
Test
0
JOG Fwd Running
＊
Test
10
JOG Rvs Running
7
1
To Next Page
Loading...
