5. INSTALLATION
5 - 9
LR
LR/3
Thrust load
F direction
F1 direction
Point
loaded
Fig. 5-9 Radially loaded position
5.3 Cable Installation
• Be careful not to give stress or damage to cables.
• When the motor and cables are moved by cable bearer, determine a bending radius of each cable by
the necessary flexure lifetime and type of wire. It is recommended that the cable of a movable portion
should have a structure that permits periodic replacement. When you desire to use a recommended
cable for a movable portion, consult with our company.
The allowable radial load refers to the maximum load applicable to the point one-third of the
output shaft length away from the output shaft (see the figure below).
To Next Page
Loading...
