Cubis
®
MCE Operating Instructions 27
Getting Started
6 Getting Started
6.1 Connecting Electronic Components
Procedure
t NOTICE Improper connection may damage the device! If the device is connected
using electronic components, e.g. printer, PC: The device must be disconnected
from the power supply. Ensure that the device is disconnected from the power
supply.
t Connect the device using electronic components (see electronic components
instructions).
6.2 Installing the AC Adapter
Procedure
t Plug the DC supply cable of the AC adapter into the device’s “power supply”
connection socket and tighten the threaded fitting.
t Connect the power supply cable to the AC adapter connection.
6.3 Connecting the Power Supply
Procedure
t
WARNING Severe injuries caused by using a defective power supply cable!
Check the power supply cable for damage, e.g., cracks in the insulation.
t If required: Contact Sartorius Service.
t Check whether the country-specific power plug matches the power connections
at the installation site.
t If required: Contact Sartorius Service.
t NOTICE Damage to the device due to excessive input voltage! Check whether the
voltage specifications on the AC adapter match those of the power supply at the
installation site.
t If the input voltage is too high: Do not connect the device to the power
supply.
t Contact Sartorius Service.
t Connect the mains plug of the power supply cable to the wall outlet at
the installation site.
y The [BOOTING] display appears in the operating display.
y The device performs a self-test.
y The device performs an initial tare function.
To Next Page
Loading...
