Cubis
®
MCE Operating Instructions 35
System Settings
Parameters in the “Settings for Printouts” Submenu
Parameters Setting values Explanation
ACTIVATE MAN. NO Manual without stability: Print process can be started manually at any time.
MAN.AFTER* Manual after stability: After pressing the [Print] key, the print command is only
executed once stability is achieved.
MAN.AT Manual at stability: Print process can be started manually when stability is achieved.
AUTO.LC Automatically at load change: Print process starts after every load change.
FORMAT 22 CHARS* Printer output prints 22 characters per line (16 characters for the measured values
and 6 characters for identifiers)
EXTR.LINE Printer output prints an additional line with the date, time, and weight value.
PRINT.INIT OFF Deactivates the output of the application parameters.
ALL* Print command prints all parameters.
MAIN PAR. Print command only prints the main parameters.
GLP OFF* Deactivates the GLP printout.
CAL.-ADJ. Activates the GLP printout for all calibration and adjustment processes.
ALWAYS The GLP printout is always switched on. All printouts contain a GLP header and a
GLP footer.
TAR./PRT. OFF* Deactivates automatic taring after printer output.
ON Automatically tares the device after every printout.
TIME 24H Sets the time to 24-hour mode.
12H Sets the time to 12-hour mode (AM / PM).
DATE DD.MMM.YY* Sets the date display format to DD.MMM.YY
MMM.DD.YY Sets the date display format to MMM.DD.YY
* Factory setting
Parameters in the “PC Direct Transfer” Submenu
Parameters Setting values Explanations
DEC.SEPAR. DEC.POINT* Sets a point as a decimal separator.
DEC.COMMA Sets a comma as a decimal separator.
OUTP.FORM. TEXT+NUM.* Exports text and numbers.
ONLY NUM. Only exports numbers.
* Factory setting
7.3.4 Parameters in the “Applications” Main Menu
Parameters in the “Weighing” Submenu
Parameters Setting values Explanation
UNIT ON* Activates the “Toggle between weight units” function.
OFF Deactivates the “Toggle between weight units” function.
* Factory setting
To Next Page
Loading...
Need help?
General