Cubis
®
MCE Operating Instructions 53
Decommissioning
11 Decommissioning
11.1 Decommissioning the Device
Procedure
t Turn the device off.
t Disconnect the device from the power supply.
t Disconnect the device from all connected devices and all accessories, e.g.
printeror electronics module.
t Clean the device (see Chapter “9.2 Cleaning the Device”, page 48).
t Re-insert all components into the device (see Chapter “9.1 Preparing the Device”,
page 48, Chapter “9.3 Assembling and Connecting the Device”, page 49).
t If below-balance weighing has been set up:
t Turn the device on its side and place it on a soft support base.
t Remove the hook for below-balance weighing from the thread.
t Insert below-balance cap (1) back into the opening (2) in the device base and
screw in with a suitable screwdriver.
t Insert the hook for below-balance weighing (2) into its retainer on the
underside of the weighing module.
t Re-insert the cover of the below-balance weighing equipment (1).
t Place the device on the device base on a level surface.
12 Transport
12.1 Transporting the Device
Procedure
t Only lift the device by its base.
t When lifting and transporting, ensure that no personnel or objects are in the
way.
t Get help from additional persons when lifting and transporting the device.
t Use suitable conveyance devices, e.g., trolleys, for long transport routes.
21
To Next Page
Loading...
Need help?
General