54 Cubis
®
MCE Operating Instructions
Storage and Shipping
13 Storage and Shipping
13.1 Storage
Procedure
t Turn the device off.
t Disconnect the device from the power supply.
t Disconnect the device from all connected devices and all accessories, e.g. printer.
t Clean the device (see Chapter “9.2 Cleaning the Device”, page 48).
t Store the device according to the ambient conditions (see Chapter 15.6,
page 58).
13.2 Returning Device and Parts
Defective devices or device components can be returned to Sartorius. Returned
devices must be clean, decontaminated, and properly packed, e.g. in the original
packaging.
Transport damage as well as measures for subsequent cleaning and disinfection of
the device or device components by Sartorius shall be charged to the sender.
WARNING
Risk of injury due to contaminated devices!
Devices contaminated with hazardous materials (nuclear, biological, or chemical –
NBC) will not be accepted for repair or disposal.
t Observe the information on decontamination (see Chapter 14.1, page 55).
Procedure
t Disconnect the device from the power supply.
t Disconnect the device from all connected devices and all accessories, e.g. printer.
t Clean the device.
t Contact Sartorius Service for instructions on how to return devices or device
components (please refer to www.sartorius.com for return instructions).
t Pack the device and the device components properly for return, e.g. in the
original packaging.
To Next Page
Loading...
Need help?
General