38 Cubis
®
MCE Operating Instructions
System Settings
7.3.5 Parameters in the “Input” Main Menu
Parameters Setting values Explanation
ID NO. Maximum of
8 characters
09-0, A-Z, - , space
Saves the entered ID number for the device.
LOT ID OFF* Deactivates the prompt of lot ID number during data output.
ON Activates the prompt of the lot ID number during data output.
DATE Saves the entered date.
TIME Saves the entered time.
USER.PASS. Maximum of
8 characters
09-0, A-Z, - , space
Saves the entered user password.
DEL.PASS. YES Deletes the entered user password.
NO* Does not delete the entered user password.
SERV.PASS. Max 8 characters
09-0, A-Z, - ,
empty
Activates service mode.
CAL.WT. Changes the calibration weight for the adjustment or calibration process with the
user-defined weight value.
* Factory setting
7.3.6 Parameters in the “Language” Main Menu
Parameters Setting values Explanation
Language ENGLISH* English
DEUTSCH German
FRANCAIS French
ITALIANO Italian
ESPANOL Spanish
PORTUG.
Portuguese
РYССKИИ
Russian
POLSKI Polish
* Factory setting
7.3.7 Parameters in the “Unit 1”, “Unit 2”, “Unit 3”, and “Unit 4” Function Menus
Parameters Setting values Explanation
The availability of units may depend on national legislation and is therefore country-
specific.
NONE* Switches the toggle between weight units off for this position.
GRAMS – Newton NONE* The configuration values for the [DISP.DIG.] parameter in the [BALANCE] menu are
saved for the scale interval ([DISP.DIG.] parameter see 7.3, 29).
ALL “Show all decimal places”: All decimal places are shown in the display.
LP.ON/OFF “Reduced by 1 decimal place for load change”: The last decimal place on the display is
switched off until stability is achieved.
DIVIS. 1 “Last decimal place of the 1st division”: The last decimal place always shows the 1st
division.
MINUS 1 “Last decimal place off”: The last decimal place is switched off and the measured value
is rounded up or down by one decimal place.
* Factory setting
To Next Page
Loading...
Need help?
General