Cubis
®
MCE Operating Instructions 37
System Settings
Parameters in the “Animal Weighing” Submenu
Parameters Setting values Explanation
ACTIVITY CALM Sets the intensity of the “Animal activity” to “calm”. Recommended for minor
movements of the sample, e.g. caused by placement on the weighing pan.
MEDIUM* Sets the intensity of the “Animal activity” to “medium”. Recommended for medium
movements of the sample, e.g. caused by placement on the weighing pan.
V.ACTIVE Sets the intensity of the “Animal activity” to “very active”. Recommended for very active
movements of the sample, e.g. caused by placement on the weighing pan.
START MANUAL The “Animal weighing” application must be manually selected in the start screen.
AUTO* Sets the trigger to start the “Animal weighing” application to “automatic”.
* Factory setting
Parameters in the “Calculation” Submenu
Parameters Setting values Explanation
METHOD MUL.* Specifies multiplication as the method of calculation for the “Calculation” application.
DIV. Specifies division as the method of calculation for the “Calculation” application.
DEC.PLCS NONE The result of the “Calculation” application is displayed without decimal places.
1 DEC.PL.* The result of the “Calculation” application is displayed to 1 decimal place.
2 DEC.PL. The result of the “Calculation” application is displayed to 2 decimal places.
3 DEC.PL. The result of the “Calculation” application is displayed to 3 decimal places.
* Factory setting
Parameters in the “Density Determination” Submenu
Parameters Setting values Explanation
DEC.PLCS NONE The result of the “Density determination” application is displayed without decimal
places.
1 DEC.PL.* The result of the “Density determination” application is displayed to 1 decimal place.
2 DEC.PL. The result of the “Density determination” application is displayed to 2 decimal places.
3 DEC.PL. The result of the “Density determination” application is displayed to 3 decimal places.
* Factory setting
Parameters in the “Statistics” Submenu
Parameters Setting values Explanation
COMP.PRT. OFF Deactivates the component printout.
ON* Activates the component printout.
TAR./STAT. OFF* Deactivates automatic taring after the components are saved.
ON Activates automatic taring after the components are saved.
* Factory setting
To Next Page
Loading...
Need help?
General