30 Cubis
®
MCE Operating Instructions
System Settings
Parameters Setting values Explanation
ST.DEL. NONE Sets the stability delay to “none”: The stability symbol is displayed after the stability
criterion is reached.
SHORT* Sets the stability delay to “short”: The stability symbol only appears after a short delay in
order to provide a reliable result despite fluctuations.
MEDIUM Sets the stability delay to “medium”: The stability symbol only appears after a longer
delay in order to provide a reliable result in case of higher fluctuations.
LONG Sets the stability delay to “long”: The stability symbol only appears after a long delay in
order to balance out major instability.
ZERO/TAR. W/O STB. Without stability: The function of the [Zero] or [Tare] key is executed immediately once
the key is pressed.
W/ STAB.* With stability: The function of the [Zero] or [Tare] key is only executed after stability is
achieved.
AT STAB. At stability: The function of the [Zero] or [Tare] key is executed if stability exists when
the key is pressed.
AUTOZER. ON* Activates automatic zeroing. The display is automatically set to zero in case of a
deviation of 0 less than (X).
OFF Deactivates automatic zeroing. Zeroing must be triggered with the [Zero] key.
UNIT The availability of units may depend on national legislation and is therefore country-
specific.
GRAMS* The device displays the weight in grams.
KILOGR. The device displays the weight in kilograms (not for semi-microbalances).
CARATS The device displays the weight in carats.
POUNDS The device displays the weight in pounds (not for semi-microbalances).
OUNCES The device displays the weight in ounces.
TROY OZ. The device displays the weight in troy ounces.
HKTAEL The device displays the weight in taels (Hong Kong).
SNGTAEL The device displays the weight in taels (Singapore).
TWNTAEL The device displays the weight in taels (Taiwan).
GRAINS The device displays the weight in grains.
PENYWT. The device displays the weight in pennyweights.
MILLIGR. The device displays the weight in milligrams.
CHINATAEL The device displays the weight in taels (China).
MOMMES The device displays the weight in mommes.
TOLA The device displays the weight in tolas.
BAHT The device displays the weight in baht.
MESGHAL The device displays the weight in mesghals.
NEWTON The device displays the weight in newtons.
DISP.DIG. ALL* “Show all decimal places”: All decimal places are shown in the display. Not available on
conformity-assessed devices.
LP.ON/OFF “Reduced by 1 decimal place for load change”:
The last decimal place on the display is switched off until stability is achieved.
DIVIS. 1 “Last decimal place of the 1st division”: The last decimal place always shows the 1st
division.
MINUS 1 “Last decimal place off”: The last decimal place is switched off.
* Factory setting
To Next Page
Loading...
Need help?
General