Sartorius Entris II BCA Advanced Series - Parameters in the Settings; Weighing; Zero;Tare Menu; Parameters in the Settings; Printout Menu

22 Entris
®
II Advanced Line Operating Instructions
Operating Concept
4.11.5 Parameters in the “Settings / Weighing / Zero/Tare” Menu
Parameters Settings Explanation
Zero / tare
function
Without
stability
The function of the [Zero] or [Tare] button is executed immediately once the
button is pressed.
With stability* The function of the [Zero] or [Tare] button is executed if stability exists when the
button is pressed.
Automatic
zero
On* Activates automatic zeroing. The display is automatically set to zero in case of a
deviation of 0 less than (X).
Off Deactivates automatic zeroing. Zeroing must be triggered with the [Zero]
button.
Zero / tare at
power on
On* Activates the initial taring / zeroing. The device is tared or zeroed after it is
switched on.
Off Deactivates the initial taring / zeroing. After it is switched on, the device shows
the same value as before it was last switched off.
SQmin** On* Activates the SQmin application.
Off Deactivates the SQmin application.
* Factory setting
4.11.6 Parameters in the “Settings / Printout” Menu
Parameters Settings Explanation
Printout Manual
without
stability
The print process can be started manually at any time.
Manual with
stability*
If the [Print] button is pressed: The print command is only executed once stability
is achieved.
Auto without
stability
 The data is printed automatically.
 No stability is required for printout.
 The printout can be without unit symbols.
Auto without
stability
 The data is printed automatically.
 No stability is required for printout.
Print after
weight
change
Prints after a threshold for device stability has been exceeded and the weight has
previously been reduced to less than half of the threshold.
* Factory setting