Sartorius Entris II BCA Advanced Series - Parameters in the Settings; SBI Protocol Menu

24 Entris
®
II Advanced Line Operating Instructions
Operating Concept
Parameters Settings Explanation
Sample ID
function
On  Activates the sample ID.
 The sample ID is queried before each printout.
Autom.
increment
Counts up the sample ID automatically.
Autom.
decrement
Counts down the sample ID automatically.
Off* Deactivates the sample ID.
Sample ID2
function
On  Activates the sample ID2.
 The sample ID is queried before each printout.
Autom.
increment
Counts up the sample ID2 automatically.
Autom.
decrement
Counts down the sample ID2 automatically.
Off* Deactivates the sample ID2.
* Factory setting
4.11.10 Parameters in the “Settings / SBI Protocol” Menu
Parameters Settings Explanation
SBI function Manual
without
stability
If a print command is given, e.g., via the [print] button: The weight value is
printed.
Manual with
stability*
If a print command is given, e.g., via the [print] button: The weight value not is
printed until the device is stable.
Auto without
stability
Prints the weight value automatically without device stability.
Auto without
stability
Prints the weight value automatically only when the device is stable.
Print after
weight
change
Prints after a threshold for device stability has been exceeded and the weight has
previously been reduced to less than half of the threshold.
Manual print
format
Value w/o
identifier
Prints the weight value without labeling, e.g., “Net” or “G”.
Value* Prints the weight value.
Date, Value Prints the weight value and a time stamp.
Value (N, T,
G#)
Prints a weight value block (net, tare, calculated gross).
Date, Value
(N, T, G#)
Prints a time stamp and a weight value block (net, tare, calculated gross value).
* Factory setting