34 Entris
®
II Advanced Line Operating Instructions
Installation
5 Installation
5.1 Scope of Delivery
Item Quantity
Device 1
Weighing pan 1
Frame draft shield 1
Power supply unit with country-specific
AC adapters
1
Shock absorber 4
Operating Instructions 1
5.2 Selecting an Installation Site
Procedure
t Make sure that the following conditions are met at
the installation site:
Condition Characteristics
Ambient conditions Suitability tested (see
ambient conditions)
Setup surface Stable, even surface with
little vibration
Sufficient space for the
device (for space
requirements, see
Chapter “14.10 Device
Dimensions”, page 49)
Sufficient load-bearing
capacity for the device
and peripheral devices
(see Chapter “14.12
Metrological Data”,
page 50for device
weight)
5.3 Unpacking the Device
Procedure
t Unpack the device.
t Install the device at the intended installation site.
t We recommend keeping the original packaging to
return the device securely and appropriately, e.g. for
repairs.
5.4 Removing the Transport Lock
Procedure
1
t Remove the
transport locks (1)
and retain them for
later use.
5.5 Mounting the Device
Procedure
1
2
3
t Place the frame
draft shield (3) on
the balance.
t Attach the four
shock absorbers (2).
t Place the weighing
pan (1) on top.
5.6 Acclimatizing
When a cold device is brought into a warmer area: The
temperature difference can lead to condensation of
humidity in the device (moisture formation). Moisture in
the device can lead to malfunctions.
Procedure
t Allow the device to acclimatize for approx. 2 hours at
the installation site. Ensure that the device is
disconnected from the power supply during that
time.
To Next Page
Loading...
