Entris
®
II Advanced Line Operating Instructions 41
Cleaning and Maintenance
8.8 Printing Weight Result With ID
Identifiers, e.g., device ID, batch ID, and sample ID, can
be assigned to the device, the sample, and to a batch.
The ID numbers are exported during ISO / GLP printout.
Requirements
The ISO / GLP printout is activated in the “Settings” /
“Printout” / “Manual print” / “ISO / GLP printout”
menu.
The device ID is set in the “Settings” / “Printout” /
“IDs” / “Set device ID” menu.
A printer or a PC is connected and configured.
Procedure
t Carry out weighing.
t Press the [Start GLP] button.
t If the “Batch ID” function is activated: Enter a batch
ID.
t If the “Sample ID” function is activated: Enter a
sample ID.
y The GLP header is printed with the device ID, the
batch ID, the sample ID, and the current weight
value.
t To exit the GLP printout: Press the [Exit GLP] button.
y The GLP footer is printed.
9 Cleaning and
Maintenance
9.1 Detaching the Frame Draft
Shield and Weighing Pan
Requirements
The device is disconnected from the power supply.
Procedure
1
2
3
t Remove the
weighing pan (1),
the four shock
absorbers (2), and
the frame draft
shield (3).
9.2 Cleaning the Device
Procedure
t Disconnect the device from the power supply.
t Only use suitable cleaning agents and cleaning
procedures and observe the product information for
the cleaning agent used (for cleaning agent, see
Chapter “14.7 Cleaning Agent”, page 48).
t Remove dust and powdery sample residue with a
brush or hand-held vacuum cleaner.
t Wipe the device and the associated components
with a slightly damp cloth. Use a mild soapy solution
or a suitable cleaning agent for more severe
contamination.
9.3 Attaching the Frame Draft
Shield and Weighing Pan
Procedure
t Put the frame draft shield, the four shock absorbers,
and the weighing pan into place.
t Connect the device to the power supply (see
9.4 Maintenance Schedule
Interval Component Action
Regularly;
depending on
the operating
conditions
Device Perform a
functional test of
the device.
Contact Sartorius
Service for this.
9.5 Software Update
For a software update, contact Sartorius Service.
To Next Page
Loading...
Need help?
General