Entris
®
II Advanced Line Operating Instructions 35
Getting Started
6.1.2 Dismantling the Power Plug Adapter
Procedure
t Press the grooved
button from above and
pull back on the power
plug adapter.
t Push the power plug
adapter out of the
power supply unit and
remove it.
6.2 Connecting the Power Supply
Procedure
t
WARNING Severe injuries caused by using
defective power supply cables! Check the power
supply cable for damage, e.g., cracks in the insulation.
t If required: Contact Sartorius Service.
t Check whether the country-specific power plug
matches the power connections at the installation
site.
t If required: Replace the country-specific power
plug adapter.
t NOTICE Damage to the device due to excessive
input voltage! Check whether the voltage
specifications on the manufacturer’s ID label match
those of the power supply at the installation site.
t If the input voltage is too high: Do not connect
the device to the power supply.
t Contact Sartorius Service.
t Connect the plug to the “Power Supply” connection.
t Connect the mains plug to the wall outlet (mains
voltage) at the installation site.
6 Getting Started
6.1 Installing the Power Supply
Unit
6.1.1 Assembling the Power Supply Unit
Item number on
packaging
Power supply unit YEPS01-
15VOW with connection cable
and country-specific power plug
adapters (packed in PE bag with
printed country identification,
e.g. EU)
YEPS01-PS8 USA and Japan (US+JP), Europe
and Russia (EU+RU), Great Britain
(UK), India (IN), South Africa (ZA),
Australia (AU), China (CN)
YEPS01-PS9 Argentina (AR), Brazil (BR), Korea
(KR)
YEPS01-PS10 China (CN)
Procedure
t Select the country-
specific power plug
adapter. The power plug
adapter must be
suitable for use with the
wall outlet at the
installation site.
t Insert the power plug
adapter into the power
supply unit. The grooved
button must be facing
upwards.
t Push the power plug adapter as far as you can until it
clicks into place.
t Check whether the power plug adapter is securely
locked in place by pulling it gently.
y If the power plug adapter does not move: It is locked
in place.
To Next Page
Loading...
