17
If the server does not close a connection, it will be closed in 20 seconds if there is no activity on
the socket. In the event a connection attempt was unsuccessful, the notification client retries
two more times before announcing a connection failure.
The server’s IP address, port number and starting Modbus register address are programmable in
the meter. See “TCP Notification Client Setup” for more information on the client setup. To
configure and enable the notification client in your meter via PAS, select Communication Setup
in the Meter Setup menu, and click on the TCP Notification Client Setup tab.
Client connections are triggered via programmable setpoints. To send event notifications to a
server, configure a setpoint to respond to desired triggers or to periodic time events and add
the "Send notification" action to the end of the setpoint actions list.
To Next Page
Loading...
Need help?
General
