satmap active12 - 11.6 POI Details Screen

Software v3.0.9915
© Satmap Systems Ltd 2015
70
11.6 POI Details Screen
(GPS MAP → MAIN MENU → OOI Menu → OOI
Folders → Select POI → Show Details)
Alternative access:
(GPS MAP/PLANNING → click on POI → Choose
Information Type → select POI via centre press →
POI details)
This screen summarises details of the POI and is
titled by the current POI name. POIs are date and
time ‘stamped’, and the following information is
given:
• Name of the POI
• Grid reference
• Distance and bearing from current location
• Elevation
• POI icon
• POI description (if added)
The highlighted green 'eye' icon indicates the POI is
visible on the map. When invisible, the 'eye' icon is
highlighted in red with a red line through it.
11. POIs (Points of Interest) (... cont)
11.3 Add POI by Grid Reference
(GPS MAP → MAIN MENU → OOI Menu → Add POI
by Grid Ref)
To create a POI by grid reference, select Add POI
by Grid Ref from the OOI Menu and press Select or
centre press the joystick. This will take you to the
SETTING screen where you will be able to create a
POI using a grid reference.
To add a location entry, move the joystick left/right to
toggle between boxes. Move the joystick up/down to
change the box entries.
Under the grid reference boxes are the 'conversions'
showing the initial grid references. Once you begin
changing the grid reference (i.e. moving the joystick
up/down to change the entries), these conversion
figures are grayed out and the Convert button
becomes bold. Pressing Convert will update the
conversions.
11.4 Add POI by Postcode (UK only)
(GPS MAP → MAIN MENU → OOI Menu → Add POI
by Postcode)
POIs can be added by postcode for some units in
the UK. Select Add POI by Postcode from the OOI
Menu and press Select or centre press the joystick.
This will take you to the keypad. Enter the desired
postcode and press Done to go to the Add POI
screen.
Follow the steps as described in section 14.01 ('Add
POI by Map') to create your POI on the map.
11.5 Add POI in a Specic Folder
(MAIN MENU → OOI Menu → OOI Folders → specic
folder → nal subfolder → Back → Add POI by Map or
Add POI by Grid Reference or Add POI by Postcode)
This will add the POI to the last visited folder.
Note: Folders are created using SatSYNC and must
contain at least one OOI or route to be visible on the
unit. (See SatSYNC User Guide for more information).
Set location by
Grid Reference
Basic POI
detail