Software v3.0.9915
© Satmap Systems Ltd 2015
77
12. AOIs (Areas of Interest) (... cont)
12.6 Rename AOI
(GPS MAP → MAIN MENU → OOI Menu → OOI
Folders → Select AOI → Edit → Rename)
When an AOI is created it is called 'AOI 1' by default
(or similar, depending on the number of existing
OOIs).To rename it, highlight the AOI in the OOI
Folders, press Edit, then Rename
. The keypad
appears. Use the joystick to rename the AOI.
12.7 Edit Description
(GPS MAP → MAIN MENU → OOI Menu → OOI
Folders → Select AOI → Edit → Edit Description)
Highlight Edit Description, then either press the
Edit button or centre press the joystick to access
the keypad.
Operate the keypad to input comments describing
the AOI and press Done when finished. The screen
will return to the EDIT AOI menu.
Note: The 'Edit Description' option is only available if
the existing description has 128 characters or less (e.g.
externally imported descriptions from geocaches etc.
with more than 128 characters cannot be edited).
12.8 Edit Location by Map
(GPS MAP → MAIN MENU → OOI Menu → OOI
Folders → Select AOI → Edit → Edit Location by Map)
You are in edit mode when a red cross appears
inside the orange locator circle. Use the joystick to
move the locator circle over individual AOI points
and centre press the joystick to select them. A blue
POI icon appears just inside the locator circle which
means you can then drag the AOI point to a new
location. Centre press the joystick to confirm the
placement.
If you wish to add another AOI point, press the
'+'
button. To remove an existing AOI point, press the
'x' button.
Press the GPS Map button to return to the last map
screen.
12.9 Edit Visibility
(GPS MAP → MAIN MENU → OOI Menu → OOI
Folders → Select AOI → Edit → Edit Visibility)
On selecting Edit Visibility you are taken to a
menu where you can hide or show your AOIs by
setting them as 'visible' or 'not visible' on your map.
Pressing Select takes you back to the edit menu.
Note: This is only respected if the global visibility is set
to 'Default' (GPS MAP → MAIN MENU → OOI Menu
→ 'Visibility - Default').
EDIT AOI
name
EDIT AOI
POI icon
AOI
AOI
reference
point
(section
15.03)
To Next Page
Loading...
