Software v3.0.9915
© Satmap Systems Ltd 2015
82
13. LOIs (Lines of Interest) (... cont)
13.6 Rename LOI
(GPS MAP → MAIN MENU → OOI Menu → OOI
Folders → Select LOI → Edit → Rename)
When an LOI is created it is called 'LOI 1' by default
(or similar, depending on the number of existing
OOIs).To rename it, highlight the LOI in the OOI
Folders, press Edit, then Rename. The keypad
appears. Use the joystick to rename the LOI.
13.7 Edit Description
(GPS MAP → MAIN MENU → OOI Menu → OOI
Folders → Select LOI → Edit → Edit Description)
Highlight Edit Description
, then either press the
Edit button or centre press the joystick to access the
keypad (section 9.00).
Operate the keypad to input comments describing
the LOI and press Done when finished. The screen
will return to the EDIT LOI menu.
The 'Edit Description' option is only available if the
existing description has 128 characters or less (e.g.
externally imported descriptions from geocaches etc.
with more than 128 characters cannot be edited).
13.8 Edit Location by Map
(GPS MAP → MAIN MENU → OOI Menu → OOI
Folders → Select LOI → Edit → Edit Location by Map)
You are in edit mode when a red cross appears
inside the orange locator circle. Use the joystick to
move the locator circle over individual LOI points
and centre press the joystick to select them. A blue
POI icon appears just inside the locator circle which
means you can then drag the LOI point to a new
location. Centre press the joystick to confirm the
placement.
If you wish to add another LOI point, press the
'+'
button. To remove an existing LOI point, press the
'x' button.
Press the GPS Map button to return to the last map
screen.
Edit LOI name
Edit LOI
location
POI icon
LOI
LOI
reference
point
(section
16.03)
*
To Next Page
Loading...
