Section 7: Replacement Procedures
Page 7-18
CG4 Series Service Manual
7.13 CUTTER KIT/ BOARD/UNIT REPLACEMENT (OPTIONAL) (cont’d)
7.13.3 Cutter unit Replacement
8.
Peel off the Anti static sheet from the Cutter unit and put
it aside for latter use.
9. Remove three screws to detach the Cutter cover from the
Cutter unit.
10.Remove two screws with washers securing the Cutter
unit
to the Cutter holder.
11.Slide the Cutter unit upwards to detach from the Cutter
holder
.
12.Replace the new Cutter unit and follow the above steps in
reverse sequence, to reassemble the parts.
13.After replacement, perform Cutter counter clear and Cutter
Offset position adjustment. Refer to
Section 4.12 Factory
Clear Mode
and Section 6.6 Offset position Adjustment.
Notes:
• Ensure the cables are properly route after assembled
the parts of
Cutter kit. Ensure that no cables are
pinched between parts when you are installing the cutter
board to the printer.
• When pasting the
Anti static sheet, Top right corner of
Anti static sheet must meet the cross point as indicated
on the right diagram.
To Next Page
Loading...
