SATO s86ex - Page 133

4 Operation and Configuration
131
S84-ex/S86-ex Operator Manual
SELECT LANGUAGE
Set the LCD language.
The following languages are available:
•ENGLISH
• FRENCH
•GERMAN
• SPANISH
• PORTUGUESE
•ITALIAN
• CHINESE (Simplified Chinese)
• DUTCH
• RUSSIAN
PRIORITY SETTING
Set the priority for the system commands.
• COMMAND: Certain system commands that have been sent to the
printer have the priority to overwrite the printer configuration set by the
LCD operator panel.
• INTERNAL: The above mentioned printer configuration set by the LCD
operator panel will not be replaced by the sent command.
System commands that can be assigned priority are as follows:
Print Darkness <#E>, Print Darkness <#F>, Print Speed <CS>, Position
Offset <A3>, Print Mode <PM>, Print Method <PH>
RIBBON NEAR END
Enable or disable the detection of the ribbon near end.
• ENABLE: Detect and notify when the ribbon is about to run out.
• DISABLE: Do not detect the ribbon near end.
Note
Shows for the thermal transfer model only.
LABEL RE-DETECT
Set whether or not to re-detect the label pitch when the power is on after
the head opens/closes.
• ENABLE: Re-detect the label pitch.
• DISABLE: Do not re-detect the label pitch.