SATO s86ex - Page 134

4 Operation and Configuration
132
S84-ex/S86-ex Operator Manual
SET PASSWORD
Enable or disable password input to various modes.
• ON: Password input is required to enter various modes.
• OFF: Password input is not required to enter various modes.
You can enable password input for the following modes:
USER MODE, INTERFACE MODE, MEMORY MODE,
ADVANCED MODE, HEX DUMP MODE and SERVICE MODE.
PASSWORD NO.
Set the four digit password for entering various modes.
Move the cursor using the
/ buttons, change the value using the
/
buttons and then press the ENTER button to confirm the
password.
COMPATIBLE MODE
Set the compatibility with the printer operation of existing models.
• ON: Keep the compatibility with the printer operation of existing models.
• OFF: Disable the compatibility with the printer operation of existing
models.
Note
For details on the compatible mode, refer to Section 8.3 About
Compatible Mode.